View source for Raspberry Pi CNC User Interface SD Card Image V2.00

To make things easier, we created a pre-configured bCNC Raspberry Pi image.

'''The Image has the following features installed and configured :'''

* '''bCNC [Version 0.9.1]''' [https://github.com/vlachoudis/bCNC Link] - Located on the desktop.
* '''CNC.js [Version 1.0.0 ]''' [https://github.com/cheton/cnc.js Link] - Server shortcut to start it is on the desktop. (Run the shortcut once and go to the RPI's http://<RPI-IP>:8000)


* XRDB - The Raspberry Pi can be accessed via Remote Desktop.
* TightVNCServer - Alternative to XRDB
* CuteCom - Very simple to use serial terminal.
* SSH has been enabled
* The image is less than 5GB uncompressed and we recommend using a 8GB SD-card.
* The hardware serial port has been configured as [/dev/ttyAMA0]. The Raspberry Pi 3 needs and extra step.(Below)
* NodeJS installed
** '''Please run the "RPi3 Serial Config" shortcut on the desktop to configure the hardware serial port on Raspberry Pi 3's.''' 


'''Login credentails(SSH & RDP):'''
* Username : pi
* Password : raspberry


'''Download (2Gb Zip):'''

Version 2 (Release Date : 2016/03/21)
* [https://drive.google.com/file/d/0BwixbCKAVT4gQTVHWFl0bVN0TTg/view?usp=sharing Mirror 1] (Hosted on Google Drive)
* [https://drive.google.com/file/d/0BwixbCKAVT4gNmVHbFNEcFdxYlE/view?usp=sharing Mirror 2] (Hosted on Google Drive)
* [https://drive.google.com/file/d/0BwixbCKAVT4gT0ZlYXZqa29OX0k/view?usp=sharing Mirror 3] (Hosted on Google Drive)


'''Tested on:''' 
* Raspberry Pi 3
* Raspberry Pi 2 
* Raspberry Pi 1 B+ (Version with 40 Pin header)


'''Installing the image:'''
[https://www.raspberrypi.org/documentation/installation/installing-images/README.md Raspberry Pi Image Installation Guide]


'''FAQ and Forum discusions on this topic'''
* [http://forum.protoneer.co.nz/viewforum.php?f=7 Raspberry Pi CNC Board - Forum]
* [http://forum.protoneer.co.nz/viewforum.php?f=16 Raspberry Pi CNC Board Image - Forum]