Raspberry Pi CNC User Interface SD Card Image V5.00

From Protoneer - Wiki
Jump to: navigation, search
Download (2Gb Zip):

Version 5.10 (Release Date: 2020/04/12)
Raspberry Pi CNC Hat Image - Download 1

To make things easier, we created a pre-configured Raspberry Pi image.

The Image has the following features installed and configured :

  • bCNC [ Version 0.9.14 ] Link - Located on the desktop.
  • CNC.js [ Version v1.9.20 ] Link - Server shortcut to start it is on the desktop. (Run the shortcut once and go to the RPI's http://<RPI-IP>:8000)
  • Arduino [ Version 1.8.10 ] Link
  • AVRDude-RPI [ Customized ] - Programs Atmega328/Atmega2560's via Arduino IDE connected to /dev/ttyAMA0.

New in this release:

  • GRBL Firmware Updating Scripts - These scripts make it easy to swap between GRBL V0.9 and V1.1
  • ChiliPeppr Server Web Interface - Server shortcut on the desktop.
  • Universal Gcode Sender [ Version 1.0.9 ] Link - Server shortcut on the desktop.

  • XRDB - The Raspberry Pi can be accessed via Remote Desktop.
  • TightVNCServer - Alternative to XRDB
  • CuteCom - Very simple to use serial terminal.
  • SSH has been enabled
  • The image is less than 4.5GB uncompressed and we recommend using a 16GB SD-card.
  • The hardware serial port has been configured as [/dev/ttyAMA0]. The Raspberry Pi 3 needs and extra step.(Below)
  • NodeJS V8.11.1LTS + Yarn
  • JAVA 8
  • To setup a RPi 3/4's, run the "RPi3/4 Serial Config" shortcut on the desktop it will configure the hardware serial port and is only needed for on a RPi 3's and RPi 4's. It only needs to be run once and will automatically reboot the Pi.

Login credentails(SSH & RDP):

  • Username : pi
  • Password : raspberry

Tested on:

  • Raspberry Pi 4
  • Raspberry Pi 3 B+
  • Raspberry Pi 3
  • Raspberry Pi 2
  • Raspberry Pi 1 B+ (Version with 40 Pin header)

Known Issues

  • Shrinking the image has been an issue. We recommend using a 16GB SD Card.

Installing the image: Raspberry Pi Image Installation Guide

FAQ and Forum discusions on this topic

Old Sd card images https://wiki.protoneer.co.nz/Raspberry_Pi_CNC_User_Interface_SD_Card_Image_V4.10